No raster_Sound normal, but no picture_ Picture normal, but no sound_Some source channel work abnormally.
.jpg)
No raster (screen is not lit), no picture, no sound
If detect NS01 (main chip) pin 169 is of high level, you may remove RS14, detect VS01 emitter if first output high level after power on, then output low level continuously. If not, the reset circuit may have problem. First detect if NS01 (main chip) pin 44 waveform is sine wave, if not, check NS01 crystal oscillator circuit. When checking periphery of NS01, NS02 and NS05, check relative component’s welding, then use oscilloscope to detect the joint resistor pin between NS01 and NS05. If the waveform is not regular square-wave, that means either NS01 or NS05 work abnormally and therefore cause address line and data line be in error. NS05 error probability is greater. In addition, if joint resistor between NS01 and NS05 is in error, it will also cause no raster, no picture and no sound.
CLICK ON THE PICTURES TO ZOOM IN
Sound is normal, but no picture. (Blue screen and OSD can be displayed.) Note: HDMI channel is excluded.
Sound OK, but no picture (only backlight lights up)
Picture normal, but no sound.
Some source channel work abnormally.
Note:To get normal HDMI picture, especially when connect to DVD player with HDCP information, it must be guaranteed that NV04 and NV05 (HDMI port DDC chip) writing is correct, and especially bus between NV04, NV05 and HDMI jack must be smooth and unhindered. Secondly HOTPLUG circuit must be guaranteed (it is of high level at normal broadcast), otherwise the picture playback cannot be normal.
To get normal HDMI sound, especially when connect to DVD player with HDCP information, it must be guaranteed that NV04 and NV05 (HDMI
port DDC chip) writing is correct, and bus between NV04, NV05 and HDMI jack must be smooth and unhindered, otherwise the sound playback cannot go.
