.bmp.jpg)
AIWA XH-A1060_SPEAKER DISASSEMBLE INSTRUCTIONS.
TOOLS REQUIRED
DISASSEMBLE PROCEDURE
* Insert a flat-bladed screwdriver into the position indicated by the arrows and remove the panel. Remove the screws of each speaker unit and then remove the speaker units.
* Remove the grill frame and four pieces of rubber caps by pulling out with a flat-bladed screwdriver. Remove the screws from hole where installed rubber caps. Insert a flat-bladed screwdriver into the position indicated by the arrows and remove the panel. Remove the screws of each speaker unit and then remove the speaker units.
* Insert a flat-bladed screwdriver into the position indicated by the arrows and remove the panel. Turn the speaker unit to counterclockwise direction while inserting a flat-bladed screwdriver into one of the hollows around speaker unit, and then remove the speaker unit. After replacing the speaker unit, install it turning to clockwise direction until "click" sound comes out.
How to Remove the PANEL, FR
* Insert the (--) flat head screwdriver tip into the gap between the PANEL, FR and the PANEL, SPKR. Tap the head of the (--) flat head screwdriver with the plastic hammer head, and create the clearance as shown.
Insert the cut chisel in the clearance, and tap the head of the cut chisel with plastic hammer as shown, to remove the PANEL, FR.
* Place the speaker horizontally. Tap head of the cut chisel with plastic hammer as shown, and remove the PANEL, FR completely.
