FACTORY RESET_SOFTWARE UPDATE – DSP SCHEMATIC – JBL BD 300
5.1-channel 3-D Blu-ray home cinema system.
FACTORY RESET
* Press "SETUP" button on remote control ==> General Settings ==> System ==> Restore defaults
* Select OK ==> Press “ENTER" on remote control.
FIRMWARE UPGRADE
Upgrade from USB:
* Copy the upgrade file
JBL_Cinema_V00.XX.bin（XX is the software version）,
JBL_Cinema_MCU.bin(MCU software),
JBL_Cinema.txt (MCU MD5_File ) to USB root.
* Then insert USB ,
* start up DUT enter "set-up" into SETTINGS screen, select General Settings ==> System ==> system update ==> USB Storage.
* When upgrade file detected, press "Enter" to upgrade.
[Once you start upgrade don’t power off the DUT, after upgrade DUT will restart up later a moment time or you press button “Enter” on remote control ]
Check the version information after upgraded.
Wake up DUT, press Enter to settings and the select system information. you will see a interface as below:
(Software Version: BD100(or BD300) VXX.XX.XX MAC:XX: XX: XX: XX: XX: XX)
DSP SCHEMATIC
