Vizio TV Master Unlock Passwords:
2489, 5351, 8202, 8205, 8206
XBox 360 Reset Password:
* Go to settings and click on “PARENTAL CONTROL” and instead of entering the code; press the following button sequence; X, Y, Left Trigger, X.
* Then you will be prompted to enter a new password.
Toshiba Master Codes:
0711, 6688 and 3308.
* Try each one until one works.
* This will reset your Toshiba TV to the original settings. However, you will lose any information such as favorite channels, clocks, etc.
RCA TV Parental Reset Code:
* First select parental control from the menu. You will be asked to enter your password.
* Press and hold the “volume +” and “channel +” buttons on television (not the remote) for 8 seconds.
You will see a message that the parental controls have been unlocked.
Sharp TV Reset Sequence:
* Start but pressing the”menu” button on the TV. A message should appear to input secret number.
* Press and hold both the “VOL (+)” and the CH DOWNon the TV set until the message disappears.
This should reset all passwords and settings.
Sony TV Master Code:
4357.
Use this code when prompted and it will reset the master password.
Sony Playstation 2 & 3 Master Code:
7444.
* When it asks for the password press select on the controller.
* Then enter the master code and then you should be able to set a new lock code.
Dick Smith Television Master Code:
6666.
* Go to the “Lock Menu”.
* Enter in this default password.
Channel Master DVR:
* Find the receiver ID number by clicking “Menu” on the remote and then navigating through Setup èSystem Setup è System Information.
* Now write down the receiver ID number before the dash.
* Next, click the “Menu” button on the remote again.
* Navigate to Setup è Locks.
* Enter the last 4 digits of your receiver ID before the dash.
This will act as a temporary password.
LG Television Master Code:
* 0-3-2-5. Go to the “Menu” board.
* Scroll down to “Lock”. Then enter the pass code 0325.
Phillips TV Reset Pass code:
The default factory code number is ”0000.”
If this code doesn’t work it means it has been changed.
* To reset the code go to setup and select either the channel blocking or setup code section.
* Use the master code of 0711. The TV will give you an incorrect access code message.
*Press 0711 again. Now enter your new 4 digit code.
Zenith Master Password Reset:
* Press SETUP to display the Setup menu.
* Use the remote and enter the following 6 digit number: 210499.
* The 4 digit password should be cleared.