Modulus Home Cinema System: Sub Amplifier: Sub 100 _ INFINITY - Repair Help
MCC-1_CENTRE DISASSEMBLE
* Remove the grille.
* Remove the (7) exposed rubber grille retainers; this can be accomplished by carefully pulling them out of their cavities with long-nosed pliers or similar tool.
* Remove the (7) Phillips screws that are now exposed.
* Four additional screws lie underneath the two front trim panels; these can be carefully removed by applying a blow dryer (high or maximum) or heat gun to the trim panels. Take care not to direct the gun directly at the woofer or tweeter; do not burn yourself after each panel has been heated –gloves are recommended. See illustration. If either trim panel is damaged upon removal, order: part# MODCTRPLATE-L–Left Trim Panel: part# MODCTRPLATE-R –Right Trim Panel.
* Remove the (4) additional Phillips screws that are now exposed.
* Carefully lift the front baffle, with drivers attached, off the cabinet.
Reassembly: Adhesive already in place, if encrusted on the front baffle, must be removed by scraping it off as it may prevent the trim panel from sitting flush on the front baffle. New adhesive must be added to reattach the trim panel.
MODULUS MS-1 SATELLITE
* Remove the grille.
* Remove the (4) exposed rubber grille retainers; this can be accomplished by carefully pulling them out of their cavities with long-nosed pliers or similar tool.
* Remove the (4) Phillips screws that are now exposed.
* Two additional screws lie underneath the front trim panel; this can be carefully removed by applying a blow dryer (high or maximum) or heat gun to the trim panel. Take care not to direct the gun directly at the woofer or tweeter; do not burn yourself after the panel has been heated –gloves are recommended. See illustration. If this trim panel is damaged upon removal, order: part# MODSATDECCHAR (Charcoal): part# MODSATDECPLAT (Platinum)
* Remove the (2) additional Phillips screws that are now exposed.
* Carefully lift the front baffle, with drivers attached, off the cabinet.
Reassembly: Adhesive already in place, if encrusted on the front baffle, must be removed by scraping it off as it may prevent the trim panel from sitting flush on the front baffle. New adhesive must be added to reattach the trim panel.
SCHEMATICS
