- Disconnect P3500, P3501, P3502, P1200, P700 and P600.
- Remove any tape holding down any cables. Remove the 6 screws indicated by the arrows.
- Remove decorative plastic and remove the board.
- Remove the 8 screws indicated by the arrows. Remove the Inverter Shield.
- Disconnect CN1, CN3, CN4 and CN306. Remove the Inverter.
Removing the Inverter Board (Chocolate Notice) Back Side of the board.
- On the backside of the Inverter are 5 pieces of Chocolate, (Heat Transfer and Noise reduction pads). Be sure to replace these on the New Inverter if the board is replaced. Be sure they don’t fall off if the Inverter is removed.
REMOVING MAIN POWER SUPPLY BOARD
- Disconnect P201, P203, AC In SK100 and SK101.
- Remove the 6 screws indicated by the arrows.
CLICK ON PICTURES TO MAGNIFY