Direct code entry method
- Press the "CODE SEARCH" button until the indicator light illuminates, then release.
- Press and release the device (VCR, TV, Cable etc.) button. If programming for AUX, press and release AUX button first, then press the device type to be programmed. The indicator light blinks and then remains lit.
- Enter the 3-digit code number. After you enter a valid three-digit code, the indicator light turns off.
- With your device on, press a button (ON/OFF, "PROGRAM UP/DOWN" OR "VOLUM UP/DOWN") to test. If your TV doesn’t respond, repeat the steps above, entering the next code for your brand.
- Press the "CODE SEARCH" button until the indicator light illuminates, then release.
- Press and release the VCR, TV or Cable button. If programming for AUX, press and release AUX button first, then press the device type to be programmed.
- Press "ON/OFF" repeatedly until the device turns off. Note that because there are so many codes, you may have to press the "ON/OFF" button a few hundred times if your code is towards the end in the list.
- When your device shuts off, press and release the "ENTER" button.
- With your device on, press a frequently used button like "PROGRAM UP/DOWN" OR "VOLUM UP/DOWN" to test.
- If it does not function correctly, repeat steps 1 through 6.
- Turn on the device you want the remote to operate.
- Press and hold the "CODE SEARCH" button until the indicator light illuminates, then release.
- Press and release the device key that corresponds to the equipment you want the remote to operate (TV, VCR/DVD or DBS/CABLE etc.). The indicator light blinks once and then remains lit.
- Aim the remote at the device and press the ON/OFF key once. The remote automatically sends every code for the specified component one at a time, with a a few seconds delay between each code. Keep the remote aimed at the component throughout the process.
- As soon as the component turns off, you must press the "ENTER" button immediately for the remote to store the correct code. If you don't press "ENTER" within a few seconds, the remote will send the next code in the list and you will have to start over from Step 2.
Code retrieval procedure
- Press and hold the "CODE SEARCH" button until the indicator light turns on, then release.
- Press and release the device key that matches the equipment's code you are retrieving (TV, VCR/DVD, DBS/CABLE, etc.). The indicator light will blink once then remains lit.
- Press and release the "CODE SEARCH" key. The indicator light will turn off. Starting with 0, press the number keys in order (0-9) until the indicator light blinks.
- The number that causes the indicator light to blink is the first digit of your code.
- Repeat Step 4 until you have retrieved all 3 numbers of your code.
- Press and hold the "SLEEP" key, then release. The indicator light will stay lit.
- Enter time in minutes using the numerical keypad (from 1 minute to 99 minutes). For 1 to 9 minutes press 0 before the actual number. The indicator light will go off. Leave the remote aimed at the TV set.
- The Sleep timer program can be cancelled (reset to zero) by pressing and holding the "SLEEP" button until the INDICATOR LIGHT blinks or by pressing the ON/OFF button.