Remove the two screws
Disconnect the flexible cable and remove the two screws.
Remove the screw.
Release the tab.
Remove the guide shaft
The nut unit is not the part of optical pick-up. Before replacing the optical pick-up remove the nut unit for use with the new optical pick-up.
After installation use screw lock to lock the screw in position.
When re-assembling, use the screw lock to lock the screw in position after attaching it.
Install the optical pick-up. [Take care not to attach the tilt spring and guide shaft in wrong order.
Insert the pick-up FPC into connector FP5201 on the module PCB.
Adjust the optical pick-up tilt after removing the solder.
Remove three screws. Be sure to adjust the optical pick-up tilt after replacing the spindle motor unit.
