- Slide access door away from housing assembly.
- Remove connector from lamp. Note: Connector has 2 different size holes.
- Slide lamp away from lamp housing assembly.
- Observe the correct path for lamp wires.
- Remove the 4-torx screws from left outer housing with a T-15 screwdriver.
- Reach under label and peel away from housing.
- Open outer housing this way to avoid stress on ribbon cable.
- Disconnect locking connector.
- Observe the correct positioning of ribbon cable in left outer housing.
- Remove the 6 Phillips head screws that hold the switch PCB to the left outer housing.
- The switch pad is attached to the left and right switch PCB by rubber tabs. Gently pull tabs away from switch PCB.
- Logic PCB is removed by removing connectors and 4 Phillips head screws. Note connector orientation and wire harness path on Logic PCB. Fan wire exits on left side.
- Gently pull the light director from focusing sleeve.
- Observe the positioning of plastic tie wrap. This tie wrap serves as a polarizing filter brake.
- Unscrew focusing sleeve from lamp housing. Note orientation of light director, filter and focusing sleeve.
- The glass rod/ferrule assembly may come out with the focusing sleeve. Do not lose the UV filter in the end of the brass ferrule.
- Camera chassis removal, from the right housing is accomplished by removing the 3 torx T-15 screws from right outer housing.
- Remove camera from right housing.
- Unscrew outer lens.
- Remove lens gasket and lens filter. Note lens filter tab orientation.
- Removal of ballast PCB is accomplished by removing connector and 4 screws.
- Unscrew three Phillips head screws for Sony camera removal.
- Gently pull camera from chassis.
