- Close the notebook and position the notebook so the rear panel faces forward.
- Remove the two T8M2.0×8.0 screws that secure the hinge covers to the notebook
- Position the notebook so the front faces forward and open the notebook as far as it will open.
- Remove the display hinge covers by inserting a flat-bladed tool under the covers and lifting them up. [The hinge covers are included in the Miscellaneous Plastics Kit, spare part number 325528-001.]
- Remove the wireless antenna cables [1] and [2]from the routing channel in the top cover [3].
- Disconnect the display inverter[1] and video cables [2]from the system board.
- Remove the two {T8M2.0×8.0} screws[3]that secure the display assembly to the base enclosure.
- Disconnecting the Display Cables and Removing the Display Assembly Screws.
- Lift the display assembly straight up and remove it. Reverse the above procedure to install the display assembly.
