PREPARATION
- Input an APL 100 % white signal.
- Set the picture controls: -Picture mode: Normal. White balance: Cool. Aspect: 16:9.
Adjust driver section voltages referring the panel data on the panel data label.
TH-37PX50U
TH-42PX50U
TH-50PX50U
PANEL LABEL INFORMATION
PRINTED CIRCUIT BOARD EXCHANGE
To remove P.C.B. wait 1 minute after power was off for discharge from electrolysis capacitors.
QUICK ADJUSTMENT AFTER BOARD EXCHANGE {Click on pictures to Magnify}
TH-37PX50U
TH-42PX50U
TH-50PX50U
ADJUSTMENT VOLUME LOCATION & TEST POINTS
TH-37PX50U
TEST POINTS
TH-42PX50U
TEST POINTS
TH-50PX50U
TEST POINTS
HOTEL MODE
Access command
- Press MUTE button on remote control. Hold few seconds.
- Press the CH ▲/▼ button and VOL ▲/▼ button to Set the data of EEPROM(ADDRESS 1584) to 01
- Push the Power switch (button) off/on the set (the remote control) to turn the set off/on.
- First, set the data of EEPROM (ADDRESS 1584) to 00.
- Push the Power switch (button) off/on the set (the remote control) to turn the set off/on. Then, it is no longer hotel mode.
In order to display the Hotel mode setup menu, enter the following command (within 2 second).
[TV] : Vol. ▼ + [REMOTE] : TV/VIDEO (3 times).