Remove the two screws and remove the stand.
Pull out the hinge cover follow the arrowhead direction and remove it, then remove the hinge.
Click on the pictures to Zoom In
Remove the two screws and remove the base.
Pry the monitor up then find out the hooks’ position, use the tool (like the picture or other card) to insert into the gap of bezel and rear cover, then turn over the monitor and take off the rear cover.
Remove the one screw and remove the keyboard.
Disconnected the keyboard connector.
Remove the screw and remove the small cover shield.
Remove the screws and then remove the shield.
Remove the screws remarked in red and disconnect connector remarked in green.
Remove the screws and remove the main frame.
Note: Make LVDS connector’s metal side down.
