APPLICABLE TO PANASONIC - TX-32LE7FA/TX-32LE7LA/TX-32LE7PA/TX-32LE7F/SA/TX-32LE7P/SA/TX-26LE7FA/TX-26LE7LA/TX-26LE7PA/TX-R32LE7A/TX-R26LE7A
How to enter Service 1
* Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1.
Key Command
* Press the RED / GREEN buttons to step up / down through the functions.
* Press the YELLOW / BLUE buttons to alter the function values, to alter White Raster use +/-buttons
* Press the OK button after each adjustment has been made to store the required values.
* To exit the Service Mode, press the "N" button.Self Check
Self-check is used to automatically check the bus lines and hexadecimal code of the TV set. To enter Self-Check mode, keep pressing the STATUS [i] button on the remote control and press the down (-/v) button on the TV set.
To exit Self Check, switch off the TV set at the power button.
If the CCU ports have been checked and found to be incorrect or not located then " - - " will appear in place of "O.K."
SMPS SCHEMATIC
CLICK ON THE SCHEMATIC TO ZOOM IN