PROGRAMMING DEVICE CONTROL
The
One For All 3 Device Universal Remote Control is preprogrammed at the factory
to operate an RCA TV, a Toshiba DVD player, and a Motorola cable box.To control
devices other than the default brands,perform the following steps; otherwise
skip this section:
- Turn on a desired device (e.g.,VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc).
NOTE:
Please read steps 2 through 4 completely before proceeding. Highlight or write
down the codes and device you wish to program before starting step 2.
- On the remote control,press a device key once (i.e., DVD/VCR,CBL/SAT,or TV).
NOTE: To program control of a VCR, PVR (or
DVR),TV/VCR Combo, or TV/VCR/DVD Player Combo press DVD/VCR once.After programming a VCR Combo device, you will be able to control
channel selection, volume, and VCR functions.
NOTE: To program control of a DVD Player,DVD
Player/VCR Combo, or TV/DVD Player Combo, press DVD/VCR once.After programming a DVD Combo device, you will be able to control
channel selection, volume, and DVD functions.
- Press and hold SET until the LED(red light) blinks twice, then release SET.
- Use the Manufacturer’s Codes [CHECKTHIS SITE] to locate the type of device and brand name and then enter the first four-digit code for your device. If performed correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code
again.
Aim
the remote control at the device and press POWER once.
The device should turn off. If it does not, repeat steps 2 through 5, trying
each code for your brand until you find one that works. If it still doesn’t
work, try CODE SEARCH METHOD
NOTE: If the device does not have a POWER key, press PLAY
Repeat
steps 1 through 5 for each device you want to control.
CODE SEARCH METHOD
For
example, to search for a code for your TV:
- On the remote control, press TV once.
- Press and hold SET until the LED(red light) blinks twice, then release SET.
- Enter9 - 9- 1.TheLED will blink twice.
- Aim the remote control at the TV and slowly alternate between pressing POWERand TV. Stop when the TV turns off (after pressing POWER). If the device does not have a Power key, you can substitute another function, such as digits 0~ 9 ,CH UP or PLAY).
NOTE:
In the search mode, the remote control will send IR codes from its library to
the selected device, starting with the most popular code first.
- To lock in the code, press and release SET.TheLED will blink twice.
To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate device key for the device you are searching for.