- Disassembly of Front Panel Unit
- Disconnect connectors (CN2803, CN2806, CN2951, CN5950 & CN5951).
- Bent the front panel unit slightly forward as arrow shown.
- Release 2 claws outwards.
Ensure 2 claws located at the bottom chassis is seated into the 2 slots at bottom of front panel at 2 catches (one on each side) of bottom chassis to be aligned to front panel’s slot. Assembly is secured upon hearing clicking sound.
Disassembly for Panel P.C.B.
- Remove the volume knob.
- Remove Lid. Note: Do not misplace the spring.
- Remove 12 screws.
- Release 2 catches
- Remove Panel P.C.B.
- Lift the spring sidewards.
- Remove Lid. Note: Do not misplace the spring.
- Detach FFC cable (CN971).
- Disconnect FFC cable (CN1001).
- Remove the 5 screws.
- Push the lever upward, and then open the cassette lid ass’y (For DECK1 and DECK2).
- Tilt the cassette mechanism unit in the direction of arrow (1), and then remove it in the direction of arrow (2).
Disassembly of Deck P.C.B.
- Remove 2 screws.
- Desolder wire at deck motor terminals (W1002)
- Remove Deck P.C.B.
- Ensure all the trays are in the “STOCK” position before proceeding to the disassemble of traverse unit. For procedures to set the trays in “STOCK” position.
- Press and hold the plunger lever and rotate the gear as arrows shown until it stop.
- Push the traverse slide plate as arrow shown to release the traverse unit.
- Remove the traverse unit as arrow shown.
- Turn over the unit and install the traverse unit.
