PSU Schematics. PD46A0_BSM (BN44-00422A) PD46A1_BSM (BN44-00423A) Models: UN46D6003SFXZC, UN40D6000SFXZA, UN40d5500RF
Using: SEM5025(SMPS control IC), FSFR-1700XSL, TK8A50D(FET)
PD46A0 BSM (BN44-00422A)
PD46A1 BSM (BN44-00423A)
The output to excite the LEDs behaves like a current source of 300mA approx.
It means that the current tries to be constant and it is the output voltage that varies. This can down even to 118V.
When there is not enough loads in the exit, the source of LEDs has hiccups. (From 800 ohm approx.)
The hiccup manifests like this: the Drive. LED + se activate and rises to 322V (completely without load).
At that time the whole source is turned off, with a voltage high (3V approx.) by pin 9, which immediately returns at 0.1V. Notwithstanding the source Drive. LED + delay seconds to restart. The sample of OVP comes to the integrated by leg 12. But if it registers short, it is completely inhibited, both Drive. led +, as Drive. led- (0V in both outputs), and as soon as the short disappears, the source restarts.
When registering short, pin 6 goes up to 11.2V. The 14 goes down to 2V. The maximum current is around 0.33A, when the exit of Drive. led + is so minimal, that it only exceeds by 3V to the input source.
100-240V 50 / 60HZ 2.5A
A5V 5.3V / 100mA
B5V 46A0 5.3V / 2.9A
B5V 46A1 5.3V / 3.5A
B13V 46A0 12.8V / 1.49A
B13V 46A1 12.8V / 3.17A
VAMP 12.8V / 0.29A
Led Driver (TOP1 +) 255V / 308MA)
Model N46A0 PSLF121A03A, 46A1 PSLF151A03A
If the voltage at pin 13 drops to 0V, the source Drive. LED + is suspended. If the 116V exist, the LEDs they lower the brightness but they do not extinguish.
That means that Drive. LED- is still active Without RL it delivers fluctuating 315V.
That means that Drive. LED + works,
Drive. LED- is suspended.