- Remove one screw at rear panel.
- Detach the FFC wires (CN2801 & CN2805).
- Release the claws of both ends, and then lift up the CD Mechanism Unit.
- Remove 4 screws.
- Remove the CD chassis.
- Lay the CD mechanism unit as shown.
LASER ASS'Y
MAIN PCB
- Disconnect FFC wires CN2803 & CN2806from Main P.C.B.
- Lift up Main P.C.B. by disconnecting connectors CN5800 & CN5801 as arrow shown.
- Remove the 2 screws fixed at Sub Power P.C.B.
- Remove 2 screws at Power Amplifier IC.
- Disconnect connector CN5803
- Lift up the Sub Power P.C.B. to remove it.
POWER AMPLIFIER IC REPLACEMENT
![]()
![]()
![]()
- Desolder the terminals of Power Amplifier IC and replace the component.
- Remove the 2 screws fixed at heat sink.
- Remove 1 screw fixed at Power P.C.B.
Insulate the Power P.C.B. with insulation material to avoid short circuit.